Replace your cracked up plastic cable holder with this new engineered replacement.

Researched and developed in house in cad and tested to hold over 150lbs of tension. (We could never get it to break)

Made from high temp carbon fiber, extra strong.

It can be used for either side. Remove the old plastic from the metal as you see fit and drill a 8mm hole in the center and bend out the two side prongs slightly. See pics.

Place both cables in new holder through the slots and enclose the cable ends by pressing in side piece.

Pull the cables apart slightly allowing the bolt to go through metal bracket and through new holder.(We recommend getting a helper to pull the cables apart slightly while one person puts the bolt through.) Release cables and tighten nut (Hand Tighten only)

Attach metal piece back on your window regulator and assembly your cables on the motor and the window regulator assembly.

*Install video click here

*Hardware included.... Bolt, lock washer, nut