Automatic Transmission/Transaxle: Application and ID

^ All vehicles are equipped with a build code and information label, affixed to the LH center body pillar.
^ Refer to the code in the space marked TR on the build code and information label for proper Transaxle identification.
^ For additional information, such as model, assembly number or serial number, locate and read the Transaxle service ID tag which is attached to the main control cover.
^ The U.S. Motor Vehicle Theft Law Enforcement Act of 1984 requires identification of certain high theft vehicles to reduce the national auto theft rate. This federal law requires Ford Motor Company to affix the vehicle identification number (VIN) on specific parts. These body parts are the front bumper, the rear bumper, front fenders, hood, front doors, quarter panels and lift gate. The other affected components are engines and Transaxles. In addition the service replacement parts must also be identified as service parts.
^ The production car parts are identified by an adhesive-backed white label, approximately 2-3/16 inches long by 5/8 inch wide. Printed on this label is the VIN number and a Ford logo. The service parts are identified by a similar label, approximately 2-3/4 inches long by 5/8 inch wide. Printed on this label is the letter R and a Ford logo. Other information on this label is printed in gray lettering.
^ In the event of collision damage not requiring part replacement or drive train service, the persons making the repairs should take care not to damage or remove the labels, unless such action is reasonably necessary in performing the repair.
^ The areas selected for the location of the production and service labels are unlikely to be affected during normal servicing and non-collision repairs.