Bezel

REMOVAL
1. Disconnect the battery ground cable.
2. Remove the console finish panel.
3. Remove the two transmission range selector knob screws.
4. Remove the four transmission control selector dial bezel screws.





5. Disconnect the Transmission Control Switch (TCS) electrical connector.
6. Disconnect the shift lock actuator electrical connectors.
7. Slide the transmission range selector knob, transmission range selector cover and the transmission control selector dial bezel off of the transmission range selector.
8. Twist and pull the transmission range indicator lamp bulb from the transmission control selector dial bezel.
9. Remove the two TCS wires from the electrical connector.
10. Remove the transmission range selector knob and gearshift lever cover from the transmission control selector dial bezel.





11. Remove the two lockout switch screws.

INSTALLATION
1. Install the two lockout switch screws. Tighten the lockout switch screws to 2-2.9 Nm (17-26 inch lbs.).
2. Install the transmission range selector knob and transmission range selector cover through the transmission control selector dial bezel opening.
3. Install the two TCS wires in the electrical connector.
4. Push and twist the transmission range indicator lamp bulb into the transmission control selector dial bezel.
5. Install the transmission range selector knob gearshift lever cover and the transmission control selector dial bezel on the transmission range selector.
6. Connect the TCS electrical connector.
7. Connect the shift lock actuator electrical connectors.
8. Install the four transmission control selector dial bezel screws. Tighten the transmission control selector dial bezel screws to 2-2.9 Nm (17-26 inch lbs.).
9. Apply locking compound and install the two transmission range selector knob screws. Tighten the two transmission range selector knob screws to 2-2.9 Nm (17-26 inch lbs.).
10. Install the console finish panel.
11. Connect the battery ground cable.