Knob

REMOVAL
1. Disconnect the battery ground cable.
2. Remove the console finish panel.
3. Remove the two transmission range selector knob screws.
4. Remove the four transmission control selector dial bezel screws.





5. Disconnect the Transmission Control Switch (TCS) electrical connector.
6. Disconnect the shift lock actuator electrical connectors.
7. Slide the transmission range selector knob gearshift lever cover and the transmission control selector dial bezel off of the transmission range selector.

INSTALLATION
1. Install the transmission range selector knob, gearshift lever cover and the transmission control selector dial bezel on the transmission range selector.
2. Connect the TCS electrical connector.
3. Connect the shift lock actuator electrical connectors.
4. Install the four transmission control selector dial bezel screws. Tighten the transmission control selector dial bezel screws to 2-2.9 Nm (17-26 inch lbs.).
5. Apply locking compound and install the two transmission range selector knob screws. Tighten the two transmission range selector knob screws to 2-2.9 Nm (17-26 inch lbs.).
6. Install the console finish panel.
7. Connect the battery ground cable.